Siemens Software Partner — Platinum Expert badge
Product Engineering

Dynamic TIMs
Testing

Prove Performance
Before OEM Qualification.

Independent, ASTM D5470-aligned thermal interface material characterization using the Siemens DynTIM Dynamic TIMs Tester.

Siemens Software Partner — Platinum Expert badge
Support faster OEM design decisions. Strengthen competitive replacement opportunities. Prove performance beyond the datasheet.

Validate your TIM performance before customer qualification.

Datasheet curves rarely match real assembly behavior. Dynamic TIMs Testing using the Siemens DynTIM Dynamic TIMs Tester gives product engineers ASTM D5470-aligned Rth vs. BLT characterization across real application conditions.

Request Sample Report Request a Sample Report
THE PRODUCT ENGINEERING PROBLEM

Datasheet performance does not always match real assembly behavior.

Formulations behave differently across BLT, pressure, and surface conditions. Without real-condition characterization, qualification surprises land late — and expensive.

BLT VARIANCE
Curves shift with real BLT
Performance at the spec'd BLT is not the same as performance across the BLT range your customer will actually see.
PRESSURE EFFECTS
Compression changes outcome
Real-condition pressure exposes thin-BLT limitations and compression-floor behavior datasheets do not capture.
COMPARISON GAP
Hard to benchmark internally
Without identical test conditions, comparing your formulation to a competitor's is guesswork.

Dynamic TIMs Testing Report

DELIVERABLES
✓
Full Rth vs. BLT characterization curve
✓
Material comparison under identical test conditions
✓
Real-condition pressure and BLT analysis
✓
Post-cycling degradation or failure-mode observations, where applicable
✓
Flotherm / FLOEFD-ready data support, where applicable
✓
ASTM D5470-aligned independent report
How Product Engineers Use It
→Validate formulation behavior across real BLT ranges
→Identify thin-BLT limitations and compression floors
→Compare formulation performance against competitor materials
→Improve material recommendations before OEM qualification

Validate Your TIM Performance Before Customer Qualification.

Get independent, ASTM D5470-aligned Rth vs. BLT characterization across the pressure and thickness conditions relevant to your application.

Request Sample Report → Request a Sample Report

Looking to license Siemens Simcenter software for your own team? Visit the software sites below — software licensing only, not Dynamic TIMs Testing services.

Thermal Simulation & Testing Software
Flotherm · FLOEFD · HEEDS · Micred T3Ster · Power Tester · Simcenter Thermal
Liv · liv@electrosource.com
Visit siemens-thermal.electrosource.com →
Noise, Vibration & Harshness Software
Simcenter Testlab · Simcenter SCADAS · NVH Data Acquisition & Analysis
Kym · kym@electrosource.com
Visit nvh-siemens.electrosource.com →